Products

Block off cap m20 1.5 thread Other Information: Suits our m20 1.5 block adaptors to run remote oil filter mount. suits many Mitsubishi, Mazda, Hond...

Bosch 1000cc/1650cc & More EV1 Connector Set GRP Connector similar to Bosch #1287013003 to suit a large range of Bosch products: 1000cc Inject...

Bosch Injector Connector Set Connector set to suit Denso/Toyota factory Injectors / Bosch 2000cc / 2200cc.

Bosch Drive By Wire Pedal Connector Set Connector set to suit Bosch Drive By Wire Pedal.

Connector kit for the 3bar TMAP sensor Suits Bosch - Universal Pressure Sensor - 0261230365 Included: 3 Pins 3 Boots 1 Connector

Donuts are used to gain a tighter radius bend than our mandrel bent tube. Primarily used for tight/compact installations. sold by the HALF. They ar...

Drive Belt & Pulley to suit 1JZ & 2JZ Suits all 1JZ & 2JZ engines (Turbo and Non-Turbo, VVTi and Non-VVTi).

Drive Belt & Pulley to suit 1JZ and 2JZ (Without Air Conditioning but with Power Steering) Would Suit: Suits all 1JZ and 2JZ engines (Turbo and...

Exhaust Stainless V-Band Clamp

GRP Engineering - Exhaust Stainless V-Band Kit Kits made from high quality Stainless 304 material. Stainless Male/Female V-Band Kit with Heavy Duty...

Extractor/Exhaust Manifold Stud Nut Would Suit: Any metric stud.

Extractor/Exhaust Manifold Studs Would Suit: Any metric port.

Fire/Heat Sleeve *Price is by the metre* The fire sleeve protects hoses, wiring, vacuum lines, etc. Continuous Operating Temp: 260 Degrees (C).Max ...

GRP Engineering - Ford Barra Exhaust Manifold Gasket The GRP Engineering Ford Barra Exhaust Manifold Gasket ensures a secure seal for your Ford Bar...

Stainless Steel Flange & Stainless Steel V-Band Clamp 2.5" V-Band Exhaust Housing Flange & Clamp Kit for turbine housing inlet. This is typ...

Garrett Turbine Outlet/Dump Pipe V-Band Kit GRP Engineering stainless V-band & clamp kit for the outlet/dump pipe flange. This allows you to fa...

Description: GRP Delphi 3 Pin Pressure Sensor Connector - Plug and Pins Only Suit: TI Map Sensors

Injector Adaptor/Spacer Fuel Injector adaptors are used to lengthen short or 3/4 length injectors to 3/4 length or full length respectively. If you...

Injector Harness Adaptor Fuel injector electrical harness adaptor. The harness selection is what your current loom/harness connector is and the inj...

In house service for testing and cleaning of your used injectors. Our Haltech Elite controlled test bench replicates how your injectors run in your...

GRP Engineering Bottom End Gasket Kit/Conversion Set Would Suit: Any 1JZ/2JZ. Kit contains: - Front Crank Seal (90311-46001GRP) - Rear Main Oil ...

Oil Filter Sandwich Plate Use our GRP Oil Filter Sandwich Plate to insert in between your original 3/4 16 thread or M20x1.5 sized oil filter and fi...