This bracket is reversible to suit chassis or aftermarket fuel line configurations.

CNC Billet 6061 Aluminium - Black Anodised

-1x JZA80 Billet DBW Adaptor to suit 1UZ-FE Non-VVTi

-4x M8 Grade 316 SS Bolts

-4x M6 Grade 316 SS Bolts

-4x M6 Grade 316 SS Washers

- 2x O-Rings

Remove OEM Throttle Body as per the Toyota Soarer Repair Manual (TSRM)
Remove existing manifold studs with Vice Clamps in an anti-clockise direction
Drill out upper threads to a 9mm size to allow M8 bolt to pass through.
Ensuring 3mm O-Ring is correctly seated, Install Adaptor Plate (no OEM gasket req.)
Ensuring 2mm O-ring is correctly seated, Install Bosch 74mm DBW Adaptor.
Complete Wiring Installation - Refer Bosch Installation Instruction (not supplied).
Reinstall Intercooler Piping - Note that additional lengths or bends will be required as this throttle body is shorter than the OEM Variant.